i want to design a 3d printed enclosure for a presence sensor. it will need to fit inside a wemos d1 mini, an ld2450 sensor, the accompanying bluetooth antenna, and the cables. The d1 mini has pins inserted which increases its height by a lot. I also want everything to be press fitted, and the enclosure to have a cutout for the d1 mini. Make the front wall thin (less than 1mm thick), so the sensor will not lose any range. make sure the case consists of two parts

i want to design a 3d printed enclosure for a presence sensor. it will need to fit inside a wemos d1 mini, an ld2450 sensor, the accompanying bluetooth antenna, and the cables. The d1 mini has pins inserted which increases its height by a lot. I also want everything to be press fitted, and the enclosure to have a cutout for the d1 mini. Make the front wall thin (less than 1mm thick), so the sensor will not lose any range. make sure the case consists of two parts

162730090

596733995

Meshy-4

CC0